Use this forum to post questions and issues for discussion related to Primos cameras
By smallmunster
#343063
I bought three truth cam 03's from Dick's Sporting goods and found the battery compartments were very tight getting the batteries in. On two of the three cameras one of the battery terminals broke off when inserting the batteries. Is this normal for the primos cameras? I liked the setup on the one that actually works, but i am not sure it will last past the next time I need to get new batteries installed.
By smallmunster
#345184
I was using energizer AA batteries. They sent me two new cameras and these have slots cut to allow better battery access. I have also found it better to put the outside ends of the battery in first and push them down in the middle to seat them. The third camera that is still original has not broken like the other two using this method.
new guy

Hello I'm new to the forum. I have a cabin deep […]

Hole in the sensor cover

I know this is a older post but, browning sells pa[…]

Ridgetec lookout questions?

A bit later on this summer. Our plans have all sh[…]

first Fawn videos 2020

Must have been born early good sized already Congr[…]